Windows Nt 3.5X Printer Setup - Brother NC-series User Manual

Windows NT 3.5x Printer Setup

1. From the Windows NT Main group, double click on the Print
Manager icon.
2. Select Printer from the menu bar and click on Create Printer.
3. Enter any desired name for the printer in the Printer Name box.
4. Select the printer model in the Driver menu.
5. Choose Other (or Network Printer for V3.1 systems) from the Print
to menu.
6. Click on Hewlett-Packard Network Port.
7. Type in your desired name for the port (this name must not be an
existing port or DOS device, such as LPT1).
8. The Ethernet addresses of available print servers will appear in the
Card Address menu. Select the desired address (the address is on the
label affixed to the print server, or it can be gotten through the self-test
page)
9. Click OK.
10. If you want to share the printer, click Share the Printer on the
Network.
11. Click OK.
12. If necessary, select the appropriate printer options and then click OK.
CHAPTER 7 WINDOWS NT (DLC/LLC) CONFIGURATION
To do this on a printer that has an LCD panel: take the printer off-
line by pressing the SEL button, press and hold down the SHIFT
button then press the UP arrow button until PRINT CONFIG is
displayed, press the SET button. The printer will then print out a
configuration sheet, the sheet labeled "Print Configuration"
contains all Print Server configuration information. Put the printer
back on-line again by pressing the SEL button.
For internal Print Servers that are connected to a Brother printer
which do not have an LCD panel, refer to your printer user guide
for instructions on how to print out a configuration page.
Brother's external interfaces, which connect to the parallel
interface, have a black button recessed into the rear of the unit.
Press this button to print out a configuration sheet.
7-3