Gemini MM-4000 Operation Manual page 5

19” 4 channel mixer with effects
Hide thumbs Also See for MM-4000:
Table of Contents

Advertisement

Available languages

Available languages

CONTROLS:
(CONTINUED)
The
giving you a choice 3 frequencies (
(
) and
higher or lower the 3 separate frequencies till the sound of the music
program is appropriate for your listening environment.
The
buttons allow you to choose which channel
(
or
) will be sent to the effects section, either one or all
channels can be selected at once (
The
channel will be heard in the headphones, one or all can be pressed at
the same time, when pressed a red LED will illuminate indicating the
is in the
position
After you have chosen which input you will use with the
the corresponding
adjust the volume for that particular
The fader assignment rotary allows you to assign which two of the
channels will be controlled by the
selections for either side of the
or
will not affect the volume of any
The
allows you to mix evenly from one source to
another. On the
either channels ( ) and ( ) or channels ( ) and ( ) depending on the
position of the fader assignment push button (see above).
The
on the
need arises can be replaced.The
rails that allow the slider to ride smoothly and accurately from end to
end can be purchased from your local
.
The
determines the mix between the chosen
To the left is the
program and to the right is
Main
switch (see above).
The
has a
decibel levels of the
It also has two settings
The
display modes, In the
the headphone
, and in the
the
output levels.
The
switch allows you to change the output of the
to either
the nature of the system you are playing through, for example some
nightclub systems are wired in
choice to change the output of the
.
adjust the tone of each
) to adjust , from
's ,you can use the adjustment knobs to
).
allows you to choose which
will allow you to
.
.There are
which can be either
, In the
position the
.
The
is assignable between
is also removable and if the
(
)
, which has internal dual stainless steel
dealer.
and the
mix.
that allows you to monitor the
and
output.
allows you to choose between two
position the VU will display the levels of
position the
output or
output depending on
, this switch gives you the
to either
CONTROLS:
by
Controls the volume level of the
,
The
The
EFFECTS:
Turns the effect section
Adjusts the mix between the (
effect assigned channels and the processed (
from the effects section.
Like the
monitor the effect in the headphone before you mix it in using
Lets you choose between the 16 different built in effect choices
which consist of:
A short
this
An artificially created
simulate a highly reflective
three (3) different settings.
Is a longer
this also has three (3) different settings.
is similar to a delay effect which basically repeats the sound
.
and then decays or trails it out mimicing the sound of a canyon or
very large area with reflective qualities, this
(3) different settings.
Can be used to cancel or remove the vocals in a song so you can
sing over it.
Is a
that automatically opens and closes giving you the
sound similar to that of a
will display
A
time, which give you a tunnel or jet plane type of sound.
will automaticaly pan the sound from the left speaker to
the right speaker at a pre-determined tempo.
or
MM-4000
(CONTINUED)
knob adjust the volume of the
.
adjusts your
volume.
or
.
) input signal being sent from the
the
that mimics the sound of being in a small
has three (3) different settings.
:
that uses a plate of metal to
sound, this
that mimics the sound of being in a concert
pedal used with guitars.
sounds like two records being played at the exact same
.
) signal coming
lets you
also has
also has three
5

Advertisement

Table of Contents
loading

Table of Contents