Setting Up Power Monitoring Using The Pdu - IBM 7014-T42 User Manual

User guide

Hide thumbs Also See for 7014-T42:

Service manual (86 pages)

Manual (196 pages)

Manual (182 pages)

Table Of Contents

Table of Contents

b. Make sure that the long mounting brackets are aligned with the inside of the rack flanges.

c. Align the blank filler panel (B) on the outside of the rack flanges.

d. Attach the filler panel to the rack flanges and then to the long mounting bracket with one M6

screw (C) per bracket. Use screws that were provided with the rack mounting kit.

e. Tighten the M3 pan-head screws (D) that secure the long mounting brackets to the PDU model.

10. If the PDU model was provided with a detached power cord, connect the power cord now. Align the

connector on the power cord (A) that was provided with the PDU model with the connector on the

front of the unit (A), turning as necessary for key alignment. Then, turn the twist-lock (B) on the

connector clockwise until it locks into place.

Attention: You must disconnect the main input power before connecting or disconnecting the input

power cord from the PDU model.

Figure 46. Aligning the connector on the power cord with the PDU model

11. Route the power cord from the PDU model toward the rack side braces. Then, route the power cord

along a side brace toward the back of the rack and secure the power cord with the cable straps that

are provided with the PDU model.

12. Route the power cord toward a dedicated power source. Use the provided cable straps to secure the

power cord along the way. Use the openings in the rack if the power cord must exit the rack to

connect to a power source.

Attention: To prevent damage to a power device and other connected devices, always connect the

power device to an authorized power source for that device.

13. Connect the power cord to a properly wired and grounded dedicated power source. Then, you can

connect the servers or rack PDUs in the rack to the power outlets on the PDU model.

14. Route all of the other power cables neatly, and secure the power cables with cable straps.