Airflow Direction Adjustment; Auto Operation - Mitsubishi Heavy Industries SRK20ZJ-S User Manual

Hide thumbs Also See for SRK20ZJ-S:

Technical manual (273 pages)

Data book (60 pages)

Service manual (162 pages)

Table Of Contents

Table of Contents

Airflow direction adjustment

Up/down direction can be adjusted with the AIRFLOW

mode changes as follows:

Change on AIRFLOW (UP/DOWN) mode.

Left/right direction can be adjusted with the AIRFLOW

mode changes as follows:

Change on AIRFLOW (LEFT/RIGHT) mode.

NOTE FOR HEATING OPERATION

• When operation starts, the flap and louver direction is fixed at the horizontal / center position in order to avoid cold draft, and return to the set the position that was

set after the warm air supply is starting.

• The flap and louver direction will be controlled to the horizontal/center position when the room temperature reaches the set temperature and compressor stops or

when defrosting is in operation.

• The airflow direction cannot be set during the period mentioned above. Change the airflow direction settings after the warm air is supplied and the flap/louver goes

to the set position.

MEMORY FLAP (FLAP OR LOUVER STOPPED)

When you press the AIRFLOW (UP/DOWN or LEFT/RIGHT) button once while the flap or louver is

operating, it stops swinging at the position. Since this angle is memorized in the microcomputer, the

flap or louver will automatically be set at this angle when the next operation is started.

• Do not expose directory to airflow from the air-conditioner for a long time.

• When in COOL or DRY operation, do not operate for a long period with the

airflow blowing straight down. Otherwise, condensation may appear on the outlet

grill and drip down.

• Do not try to adjust the flaps and louvers by hand, as the control angle may

change or the flap or louver may not be closed completely.

Adjusting airflow direction