Something Not Working - Electrolux ERES3500 Instruction Booklet

Something Not Working

Before contacting your local Service Force Centre check the following point:
Problem
" " is displayed in the temperature
display.
It is too warm inside the refrigerator.
It is too cold inside the refrigerator.
Water comes out on the floor.
The compressor operates continuously.
The cabinet does not operate at all.
Cooling or interior light does not
operate. No indicator lamps light.
Sound level in cabinet is too high.
Not enough carbon dioxide in the water
Too much carbon dioxide in the water
No carbon dioxide.
Possible cause / Remedy
An error has occurred in measuring the temperature. Call your
service representative. (The cooling system will continue to
keep food products cold, but temperature adjustment will not
be possible.)
Set a lower temperature.
Put food products in the right place inside the refrigerator. See
the chapter "Temperature inside the refrigerator".
Distribute the food products to allow cold air to circulate
around them.
Make sure that the door is completely closed and that the
insulating strip is complete and clean.
Set a warmer temperature.
Place the drain hose at the back of the cabinet above the drain
bowl. See the chapter "Before using the cabinet the first time".
Set a warmer temperature.
Make sure that the door is completely closed and that the
insulating strip is complete and clean.
Power does not reach the cabinet. (Try connecting another
electrical device to the power outlet.)
The cabinet is not switched on.
The fuse has blown.
The power plug is not properly connected.
The refrigerating system will always produce some sounds. A
pulsing sound is heard when coolant is pumped inside the
cooling pipes. A ticking sound from the thermostat can be
heard when the compressor switches on and off. The sound
level varies depending on the operation of the cabinet.
If you feel the sound level is incorrect:
Make sure the pipes at the back of the cabinet not touch each
other. Carefully bend them if they do.
If the cushion spacers (between the cabinet wall and pipes)
come loose, put them back in place again.
Carefully follow the instructions in the chapter "Installing the
cabinet".
Incoming water pressure too low.
Drain off a large amount of carbonated water (about 1 litre)
The carbon dioxide is running out. Replace the gas cylinder.
Storage temperature too high. Lower the temperature in the
refrigerator.
Dilute with ordinary water. (See the section "The water
dispenser functions")
The gas cylinder is empty. Replace the gas cylinder.
Drain off a large amount of carbonated water (about 1 litre)
Incoming water pressure too low.
11
GB
Electrolux 818 38 21-01/9