Installation Requirements; Tools And Parts - Whirlpool CABRIO Use & Care Manual

Gather the required tools and parts before starting installation.
The parts supplied are in the washer basket.
Tools needed for connecting the drain hose and water
inlet hoses:
Pliers that open to 1
(3.95 cm)
NOTE: Replace inlet hoses after 5 years of use to reduce the risk
of hose failure. Record hose installation or replacement dates for
future reference.
Parts supplied:
A B
A. Drain hose form
B. Water inlet hoses (2)
C. Flat water inlet hose washers (4)
D. Beaded tie strap
Tools needed for securing the drain hose and leveling
the washer:
Adjustable or open end
wrench " (14 mm)
Level
4

INSTALLATION REQUIREMENTS

" Flashlight (optional)
C D
Wood block
Ruler or measuring tape

Tools and Parts

Alternate Parts
Your installation may require additional parts. If you are interested
in purchasing one of the items listed here, call the toll-free
number on the cover or in the "Assistance or Service" section.
If You Have:
Laundry tub or
standpipe taller
than 96" (2.4 m)
1" (2.5 cm)
diameter standpipe
Overhead sewer
Floor drain
Water faucets
beyond reach of fill
hoses
Lint clogged drain
You Will Need to Buy:
Sump pump system (if not already
available)
2" (5 cm) diameter to 1" (2.5 cm)
diameter standpipe adapter,
Part Number 3363920 and connector kit
Part Number 285835
Standard 20 gal. (76 L) 39" (99 cm) tall
drain tub or utility sink, sump pump and
connectors (available from local
plumbing suppliers)
Siphon break, Part Number 285834;
additional drain hose,
Part Number 8318155 and connector kit,
Part Number 285835
2 longer water fill hoses:
6 ft (1.8 m) Part Number 76314,
10 ft (3.0 m) Part Number 350008
Drain protector, Part Number 367031