Table Of Contents; Installation Parts Provided - Heat Controller Energy Knight HMC30AS-1 Installation Instructions Manual

Installation
Requirements
The following should be always
observed for safety .................... 3
Installation of indoor, outdoor
unit ................................................ 4
Flaring work and connection of
piping ........................................... 6
Connection of piping(Indoor) ...... 7
For left rear piping
For right rear piping
Connection of piping(Outdoor)
................................................ 12
Connecting the cable between
indoor unit and outdoor unit ......
.................................................... 13
Checking the drainage and
Forming the piping .................. 15
Air purging ............................... 17
Charging ................................... 19
Test running ............................. 20

Installation Parts Provided

1. Type "A" screw
2. Installation Plate
3. Type "B" screw
4. Holder Remote Control
INSTALLATION OVERVIEW
Required Parts
Installation plate
Four type "A" screws
Connecting cable
Pipes: Suction line ................ 5/8"
Evaporator line .......... 3/8"
(Refer to page 4)
Insulation materials
Additional drain pipe
(Outer Diameter .... 15.5mm(0.61in))
Two type "B" screws
2
Required Tools
Level gauge
Screw driver
Electric drill
Hole core drill(ø70mm(2.76in))
Flaring tool set
Specified torque wrenches
4.2kg . m, 6.6kg . m
(different depending on model No.)
(Refer to page 10)
Spanner......................Half union
A glass of water
Screw driver
Hexagonal
wrench(4mm(0.16in))
Gas-leak detector
Vacuum pump
Gauge manifold
Owner's manual
Thermometer
Holder Remote Control