Heat Controller Energy Knight HMC30AS-1 Installation Instructions Manual page 10

Bundle the piping and drain hose together by
wrapping them with cloth tape over the range
within which they fit into the rear piping housing
section.
Drain hose
Reroute the pipings and the drain hose across
H
the back of the chassis.
Piping for
passage through
piping hole
Reinstall the parts to the original position.
I
Refix the lower panel to the original position.
The chassis bottom(A) should be connected to
the steel chassis(B) with green/yellow wiring
using two screws.
Pipe
Vinyl tape(narrow)
Wrap with
vinyl tape(wide)
Green / Yellow wire
A
Connect display conductor.
Refix the front right side panel to the original
position with the two screws.
10
Green / Yellow wire
B
Main PCB