TCT Mobile Smart III User Manual page 6

Place the SIM card with the chip facing downwards and slide it into its housing.
Make sure that it is correctly inserted. To remove the card, press and slide it
out.
Installing or removing the battery
• Insert and click the battery into place, then close the phone cover.
• Unclip the cover, then remove the battery.
Installing and removing the microSD card
To release the microSD card holder, slide it in the direction of the arrow and
lift it. Then insert the microSD card with the golden contact downward. Finally,
fold down the microSD holder and slide it in the opposite direction to lock it.
9
Charging the battery
Connect the battery charger to your phone and mains socket respectively.
• The phone will be switched on when charging the battery.
• Be careful not to force the plug into the socket.
• Make sure the battery is correctly inserted before connecting the charger.
• The mains socket must be near to the phone and easily accessible (avoid
electric extension cables).
• When using your telephone for the first time, charge the battery fully
(approximately 4 hours).
You are advised to fully charge the battery ( ). Charging status is indicated
by the depth of water on the lock screen. The depth increases as the phone
is charged.
To reduce power consumption and energy waste, when the battery is
fully charged: disconnect your charger from the plug; switch off Wi-Fi,
GPS, Bluetooth or background-running applications when not in use;
reduce the backlight time, etc.
10