Electrolux EU 6323 T Installation And Instruction Manual page 4

Installation
During normal operation, the condenser and com-
pressor at the back of the appliance heat up consi-
derably. For safety reasons, minimum ventilation
must be as shown in the relevant Figure.
Attention: keep ventilation openings clear of ob-
struction.
If the appliance is transported horizontally, it is pos-
sible that the oil contained in the compressor flows
in the refrigerant circuit. It is advisable to wait at le-
ast two hours before connecting the appliance to
allow the oil to flow back in the compressor.
There are working parts in this product which heat
up. Always ensure that there is adequate ventilation
as a failure to do this will result in component failure
and possible food loss. See installation instruc-
tions.
Parts which heat up should not be exposed. Whe-
rever possible the back of the product should be
against a wall.
If the appliance has been transported horizontally, it
is possible that the oil contained in the compressor
flows in the refrigerant circuit. It is advisable to wait
at least two hours before connecting the appliance
to allow the oil to flow back in the compressor.
Environment Protection
This appliance does not contain gasses which
could damage the ozone layer, in either its refrige-
rant circuit or insulation materials. The appliance
shall not be discarded together with the urban re-
fuse and rubbish. Avoid damaging the cooling unit,
especially at the rear near the heat exchanger. In-
formation on your local disposal sites may be
obtained from your municipal authorities.
The materials used on this appliance marked with
the symbol are recyclable.
31