Power Supply(Rechargeable Battery) - IRiver Data Play IDP-100 User Manual

POWER SUPPLY(Rechargeable Battery)

Using Rechargeable battery
Remove the cover of battery compartment at rear panel.
Connect rechargeable battery(3.7V) by matching the direction of the battery
connector, then close the cover.
CAUTION!
Do not use a different type of rechargeable battery. It may cause damage
or injury.
The life of a rechargeable battery is approximately 12 months. Contact
your distributor or our head office to purchase the battery.
28
POWER SUPPLY
Recharging Method
WARNING!
BEFORE PLUGGING IN THE PLAYER FOR THE FIRST TIME, READ THE
FOLLOWING SECTION CAREFULLY.
The voltage of the available power supply differs according to country or region. Be sure
that the power supply voltage of the area where this unit will be used meets the required
voltage (e.g., AC 230 V, 50 Hz or AC 120 V, 60 Hz) written on the adapter.
Be sure to set this switch to match the voltage of the power supply in your area before
plugging in the unit.
The charging L.E.D. indicator(Yellow) illuminates on the front panel. When charging is
done, it disappears.
Note : Use the adapter provided.
Do not use a different type of rechargeable battery, it may cause damage or injury.
Use the adapter when playing or recording for a long duration of time.
Charging time : Approx. 2.5 hours (At full discharge)
Remove the adapter from the player when not use.
Playing using the adapter
You can also play the player while charging.
External power indicator icon, as in the picture at
right, displays on the LCD.
29