Listening To The Fm Radio - Pioneer X-HM30DAB-k Operating Instructions Manual

Listening to the FM radio

STANDBY/ON
INPUT
PRESET
TUNING
TUNER/DAB
n Tuning
1 Press the STANDBY/ON button to turn the power on.
2 Press the TUNER button repeatedly to select the "FM".
3 Press the TUNING – or + button on the remote control
to tune in to the desired station.
Manual tuning:
l
Press the TUNING – or + button repeatedly to tune
in to the desired station.
Auto tuning:
l
When the TUNING – or + button is pressed for more
than 0.5 seconds, scanning will start automatically
and the tuner will stop at the first receivable
broadcast station.
Notes:
When radio interference occurs, auto scan tuning may
l
stop automatically at that point.
Auto scan tuning will skip weak signal stations.
l
To stop the auto tuning, press the TUNING – or + button
l
again.
When an RDS (Radio Data System) station is tuned in,
l
the frequency will be displayed first, and then the RDS
indicator will light up. Finally, the station name will
appear.
Full auto tuning can be achieved for RDS stations
l
"ASPM", see page 37.
To receive an FM stereo transmission:
Press the TUNER button to select stereo mode and
l
"ST" indicator will be displayed. "
appear when an FM broadcast is in stereo.
If the FM reception is weak, press the TUNER button
l
to extinguish the "ST" indicator. The reception changes
to monaural, and the sound becomes clearer.
MEMORY/FOLDER
MEMORY/FOLDER
PRESET
+
TUNING
DVD/CD
TUNER/DAB
SCAN ENTER(DAB) DISPLAY
" and " " will
n Memorising a station
You can store 40 FM stations in memory and recall them
at the push of a button. (Preset tuning)
1 Perform steps 1 - 3 in "Tuning".
2 Press the MEMORY/FOLDER button.
3 Within 30 seconds, press the PRESET – or + button to
select the preset channel number. Store the stations in
memory, in order, starting with preset channel 1.
4 Within 30 seconds, press the MEMORY/FOLDER
button to store that station in memory. If the "MEMORY"
and preset number indicators disappear before the
station is memorised, repeat the operation from step 2.
5 Repeat steps 1 - 4 to set other stations, or to change a
preset station. When a new station is stored in the
memory, the station previously memorised for that
preset channel number will be erased.
Note:
The backup function protects the memorised stations for a
few hours should there be a power failure or the AC power
lead become disconnected.
n To recall a memorised station
1 Press the PRESET – or + button for less than 0.5
seconds to select the desired station.
n To scan the preset stations
The stations saved in the memory can be scanned
automatically. (Preset memory scan)
1 Press the PRESET – or + button for more than 0.5
seconds. The preset number will flash and the
programmed stations will be tuned in sequentially, for 5
seconds each.
2 Press the PRESET – or + button again when the desired
station is located.
n To erase entire preset memory
1 Press the TUNER button on remote control or press the
INPUT button on main unit repeatedly to select Tuner
function.
2 In Tuner function, press the CLEAR button until "Tuner
Clear" appears.
En-36