Connectors - MSI Fuzzy 945GM2 User Manual

Connectors

Chassis Intrusion Connector: JCI1
This connector connects to the chassis intrusion switch cable. If the chassis is
opened, the chassis intrusion mechanism will be activated. The system will record
this status and show a warning message on the screen. To clear the warning, you
must enter the BIOS utility and clear the record.
44-Pin IDE Connector: IDE1
This 44-pin IDE connector connects to an optional converter that enables connection
to one 44-pin IDE device and one 40-pin IDE device, such as hard disk drives, CD-
ROM and other IDE devices.
IDE1
Important
If you install two IDE devices on the same cable, you must configure the drives
separately to master / slave mode by setting jumpers. Refer to IDE device's
documentation supplied by the vendors for jumper setting instructions.
1
CHASSIS
2
GND
JCI1
Connect to 44-pin
IDE device
Connect to IDE1
Hardware Setup
Connect to 40-pin
IDE device
2-9