Step 20
Lower Beam to Horizontal position as
described in the SPLITTING
OPERATION section of the manual.
Remove (2) Log Stripper Bolts and (1)
Beam Bolt Long on Engine side of the
splitter.
Position Engine Guard and reinstall (2)
Log Stripper Bolts and (1) Beam Bolt
Long as shown.
Tighten bolts to 37 lb-ft with a wrench.
Step 21
For 1108, skip to Step 22.
For 1109, 1114 – Feed Engine Switch
Cable (attached to Engine) through Cable
bushing and attach terminals to Toggle
Switch. (Black and white wire location
on switch is unimportant.)
Use (1) Cable Tie to secure Engine
Switch Cable to Engine Guard as shown.
Step 22
Fill log splitter with hydraulic fluid as
outlined in the Initial Unpacking & Set-
Up section of the manual.
Fill engine with SAE 10W-30 as
recommended by the engine
manufacturer.
Assembly Instructions
44
Toggle Switch
Engine Switch cable
Cable bushing
Cable Tie
Beam bolt long
Engine
Guard
Log Stripper
bolts