North Star M1108W Owner's Manual page 43

Step 17
 Remove the Plug on the outside of the
Control Valve.
 Thread the Large Swivel Fitting into the
Control Valve.
(Tighten the Swivel Fitting finger tight
and orient the fitting down as shown,
then Tighten the Nut on the Swivel
Fitting into Control Valve with a wrench
to 44-54 lb-ft).
Step 18
 Raise beam to vertical position as
described in the SPLITTING
OPERATION section of the manual.
 Slightly loosen Hose Clamp on to the
loose end of the Return line.
 Slide the loose end of the Return Line
onto the Return Line Fitting.
 Tighten Hose Clamp.
Step 19
 Install loose end of Hydraulic Hose into
the Large Swivel Fitting as shown and
tighten the fitting connection to 47 lb-ft
(No hydraulic sealant required).
Assembly Instructions
43
Return Line
Fitting
Swivel
Fitting
Plug Replaced
with the
Lg Swivel Fitting
Fig 02429
Return Line
Hose Clamp
Fig 02428
Hydraulic
Hose