Power Management Setup - Abit FATAL1TY-AN8-SLI User Manual

BIOS Setup

3-6. Power Management Setup

Phoenix – Award WorkstationBIOS CMOS Setup Utility
ACPI Suspend Type
- USB Resume from S3
Power Button Function
Wake-Up by PME# of PCI
Wake-Up by OnChip LAN
Wake-Up by Alarm
X - Date(of Month) Alarm
X - Time (hh:mm:ss) Alarm
Cool'n'Quiet Technology
POWER ON Function
X - KB Power ON Password
X - Hot Key Power ON
Restore on AC Power Loss
↑↓:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values
ACPI Suspend Type:
This item selects the type of Suspend mode.
[S1(PowerOn-Suspend)]: Enables the Power On Suspend function.
[S3(Suspend-To-RAM)]: Enables the Suspend to RAM function.
! USB Resume from S3:
Two options are available: Disabled or Enabled. The default setting is Disabled. When set to Enabled,
any event related to onchip USB will power on the system. This item can be configured only if the item
"ACPI Suspend Type" is set to [S3(STR)].
Power Button Function:
Two options are available: Delay 4 Sec or Instant-Off. The default setting is Instant-Off. It is activated
when the user presses the power button for more than four seconds while the system is in the working
state, then the system will transition to the soft-off (Power off by software). This is called the power
button over-ride.
Wakeup by PME# of PCI:
Two options are available: Disabled or Enabled. The default setting is Enabled. When set to Enabled, any
event related to PCI cards (PME) will power on the system.
Wake-Up by OnChip LAN:
When set to [Enabled], you can remotely wake up a PC in Soft-Off condition via a LAN card that support
the wake up function.
Wake-Up by Alarm:
Two options are available: Disabled or Enabled. The default setting is Disabled. When set to Enabled,
you can set the date and time at which the RTC (real-time clock) alarm awakens the system from Suspend
Power Management Setup
S3(Suspend-to-RAM
Enabled
Instant-Off
Enabled
Enabled
Disabled
0
0 : 0 : 0
Disabled
BUTTON ONLY
Enter
Ctrl-F1
Power Off
F6: Fail-Safe Defaults
Item Help
F7: Optimized Defaults
User's Manual
3-23