Abit KV-82 User Manual page 38

3-16 Chapter 3
IRQ/Event Activity Detect:
Click <Enter> key to enter its submenu:
VGA:
Two items available: OFF or ON. The default setting is OFF. When set to ON, any event occurring at a
VGA port will awaken a system that has powered down.
LPT & COM:
Four items are available: NONE LPT COM LPT/COM. The default setting is LPT/COM. When
set to LPT/COM, any event occurring at a LPT (printer) or COM (serial) port will awaken a system that
has powered down.
HDD & FDD:
Two items are available: OFF or ON. The default setting is ON. When set to ON, any event affecting a
hard disk drive or floppy drive port will awaken a system that has powered down.
PCI Master:
Two items are available: OFF or ON. The default setting is OFF. When set to ON, any event affecting the
PCI Master signal will awaken a system that has powered down.
Wake-up by PME# of PCI:
When set to [Enabled], access to the onboard LAN or a PCI card such as a modem or LAN card will
cause the system to wake up. The PCI card must support the wake up function.
Resume by Ring:
When set to [Enabled], any event affecting from Modem Ring will awaken a system that has been
powered down.
Wakeup by Alarm:
When set to [Enabled], you can set the date and time you would like the Soft-Off PC to power-on in the
"Date (of Month) Alarm" and "Time (hh:mm:ss) Alarm" items. However, if the system is being
accessed by incoming calls or the network (Resume On Ring/LAN) prior to the date and time set in these
items, the system will give priority to the incoming calls or network instead.
KV-80/KV-81/KV-82