Table of Contents
Advertisement
Basic operations
Playback
$ To play back a clip immediately after startup
When the PLAY key is pressed, the selected clip is played
back.
<Note>
In the playback mode established immediately after start-
up, the first clip recorded in the unit is selected. No clips
are selected immediately after all the clips have been
cleared.
O When the SHIFT key and FF key are pressed at the
same time, the next clip is selected.
O When the SHIFT key and REW key are pressed at the
same time, the previous clip is selected.
$ To play back a clip after it was recorded
Immediately after a clip has been recorded, the unit is at
the final recording position of that clip.
To return to the beginning of the currently selected clip,
press the REW key and SHIFT key at the same time.
$ To play back a different clip after clip playback and
recording
Select the clip to be played back.
O When the SHIFT key and FF key are pressed at the
same time, the next clip is selected.
O When the SHIFT key and REW key are pressed at the
same time, the previous clip is selected.
$ Loop playback mode and normal playback mode
There are two playback modes: the loop playback mode
(LOOP PB=ON) and the normal playback mode (LOOP
PB=OFF). Set the mode on the setup menu.
O Loop playback mode (LOOP PB=ON)
All the clips are played back continuously in sequence
starting with the currently selected clip.
To stop clip playback press the STOP, REW or FF key.
O Normal playback mode (LOOP PB=OFF)
In this mode, playback of the selected clips starts from
the current position to the end, after which playback
stops.
Forward and Backward searches
Press the FF key or REW key.
The frames are played back in line with the speed which
was set on the setup menu (FF or REW SPEED).
Setup
1.
Press the [1] (right) key in any mode except REC, and
set the unit to the MENU mode.
2.
Press the [1] (right) key to move the cursor to SETUP
and then press the SET key.
3.
Press the SET key again.
4.
Select the parameter item to be set using the [#] (up)
key or [2] (down) key.
5.
After changing the selected parameter item, keep
pressing the SET key until the "COMPLETE" display
appears. The changed parameter item is now saved.
<Note>
The parameter will not be changed if the screen is
transferred from the setup screen to another screen
without first saving the changes to the parameter item.
Shutdown
1.
In the MENU mode, press the [1] (right) key to move the
cursor to END (shutdown).
2.
Press the SET key.
3.
The following message now appears.
Select YES.
<Note>
Keep pressing both the SHIFT key and the [2] (down)
key for more than 2 seconds and a shutdown confirma-
tion message will appear on END screen of this unit.
[ E N D ]
1 Y E S
4.
Press the SET key.
5.
The following message now appears.
[ E N D ]
Wa it a m o m e n t .. .. ..
6.
Upon completion of shutdown, the following message
appears.
P l e a s e t u r n o f f
P o w e r s w i t c h !
7.
Set the power switch to OFF.
N O
3 9
9 (E)
Advertisement
Table of Contents
