Mazda 6 Smart Start Manual page 6

Seats
MEMORY SEAT SWITCH (if equipped)
To Program the driver's Seat Memory Position
1
Turn the ignition switch off.
2 Adjust seat to desired position using the slide/tilt and recline switches.
3 Push and hold the memory seat SET button until a beep is heard.
4 Within 5 seconds:
• To program a memory seat button, push and hold memory button
1 or 2 until a beep sound is heard.
• To program a key, push and hold the key unlock button until a beep
sound is heard (two registered keys can be programmed).
Folding Rear Seatbacks down
Returning rear seats to
upright position
1 Raise seatbacks until they lock into position.
2 Pull on the top of the seatbacks from inside
the vehicle to make sure they are locked.
5
3 Check that all seat belts are routed properly for passenger use.
NOTE:
Left rear seat release is shown.
Using remote handle:
1 Check that rear seats are clear
of objects.
2 Open the trunk and pull the
left and/or right side remote
handle lever(s).
3 Open a rear door and fold the
rear seat forward.