Navigation System - Mazda 6 Smart Start Manual

Navigation System

TO REMOVE OR INSERT THE MAP Sd CARd:
1 Turn the vehicle ignition OFF.
2
Locate the sliding door on the lower left side
of the dash (see page 5) and slide it open (right).
• Remove card: Push the card once, then pull it out.
• Insert card: Push the card in (label-side up), then slide door closed (left).
NOTE:
•
V isit www.mazdausa.com/navigation within 60 days of vehicle delivery and
download the most recent map available for your device for free. In order to
download or upgrade your map, the TomTom Home software must be downloaded.
Please refer to the Navigation System Owners Manual section of
www.mazdausa.com/navigation for additional information.
•
Only use your MAP SD card for operating and updating your navigation system. Do not
insert the MAP SD card into another vehicle or into any other device such as a camera.
•
If your vehicle is not equipped with a factory navigation system, your audio system
can be upgraded to include navigation. Contact your Authorized Mazda Dealer for
more details.
PLANNING A ROUTE USING THE TOUCH-SCREEN
IMPORTANT: In the interest of safety and to reduce distractions while you
are driving, you should always plan a route before you start driving.
To plan a route on your Navigation system, do the following:
1
Push the NAV button to access the Navigation System.
2 Tap the screen (above) to open the MAIN MENU (below).
35
Navigation System
NOTE:
available if the vehicle is equipped with
the 5.8" LCD screen. Contact your
Authorized Mazda Dealer for more details.
3
4
Factory Navigation System is
Touch Navigate to.
Touch Address.
Sd Card