Preparing The Logger For Use - Fluke 1745-BASIC User Manual

Preparing the Logger for Use

Prepare the 1745 Logger for use with PQ Log software as follows (see
Figure 3):
1. Connect the Logger to line power. Use the power supply cables to
connect to an outlet, or to the test leads phase and neutral for Wye
configurations, or any two-phase leads for delta.
If you are powering the Logger in parallel with the test
leads, and the voltage under test at the Logger power
supply connections could be greater than 660 V RMS AC,
plug the power supply leads into an outlet instead.
Otherwise, you could damage the Logger.
2. Connect the RS232 interface cable to the serial port of your PC. Use a
USB adapter if your PC does not have a serial port.
3. Run the PQ Log software as described in the PQ Log Users Manual.
4. Set up the Logging job and transfer the settings to the Logger.
Shop for Fluke products online at:
W Caution
MyFlukeStore
www.
Power Quality Logger
Using the 1745 Power Quality Logger
.com
1.877.766.5412
13