Inside The Logger; Line Power Or Battery Mode; Replacing The Battery Pack - Fluke 1735 User Manual

Power logger

Hide thumbs Also See for 1735:

Table of Contents

1735

Users Manual

Inside the Logger

You can operate the Logger continuously with the provided charging adapter

or for a few hours with the built-in battery. The battery is to ride through

power interruptions during logging sessions, and to provide operating power

during handheld troubleshooting and analysis of signals.

If you operate your Logger with the ac adapter, the battery is charged

automatically. On the display the symbol for "plugged-in" or battery is

displayed accordingly.

If the battery is completely discharged, it takes about 4 hours to charge it

completely. It is impossible to overcharge the battery as the Logger has an

automatic charging circuit.

When LO-BAT is indicated, attach the ac adapter to recharge the battery.

If the battery life is noticeably low (see technical specification), then it has to

be replaced. Replace the battery as follows, refer to Figure 13:

1. Turn off the Logger

2. Disconnect all measuring leads

3. Open the battery compartment (two cross-notched screws)

4. Unplug and replace the battery pack. Close the battery compartment

again.

Table of Contents