Onboard Headers And Connectors - ASROCK A780GXE/128M User Manual

This Manual: http://www.manuallib.com/file/2588059

2.9 Onboard Headers and Connectors

2.9 Onboard Headers and Connectors
2.9 Onboard Headers and Connectors 2.9 Onboard Headers and Connectors 2.9 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
•
Floppy Connector
(33-pin FLOPPY1)
Pin1
(see p.13 No. 27)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE connector (Blue)
(39-pin IDE1, see p.13 No. 10)
PIN1
connect the blue end
to the motherboard
80-conductor ATA 66/100/133 cable
Note: Please refer to the instruction of your IDE device vendor for the details.
Serial ATAII Connectors
(SATAII_1:
see p.13, No. 19)
(SATAII_2:
SATAII_2 SATAII_4
see p.13, No. 20)
(SATAII_3:
see p.13, No. 18)
SATAII_1 SATAII_3
(SATAII_4:
see p.13, No. 16)
(SATAII_5:
see p.13, No. 17)
(SATAII_6:
see p.13, No. 15)
SATAII_6 connector can be used for internal storage device or be
connected to eSATAII connector to support eSATAII device. Please read
"eSATAII Interface Introduction" on page 39 for details about eSATAII
and eSATAII installation procedures.
FLOPPY1
the red-striped side to Pin1
IDE1
connect the black end
to the IDE devices
These six Serial ATAII (SATAII)
connectors support SATAII
or SATA hard disk for internal
storage devices. The current
SATAII_6
SATAII interface allows up to
3.0 Gb/s data transfer rate.
SATAII_5
3 2 3 2 3 2 3 2 3 2