Carrier PG8JEA Installation, Start-Up, Operating And Service And Maintenance Instructions page 31

4-way multipoise induced-combustion gas furnace

Hide thumbs

Table of Contents

SEE NOTES: 1,2,4,7,8,9 on the page

following these figures

Fig. 42 - - Horizontal Right Application- -Vent Elbow Right

SEE NOTES: 1,2,4,5,7,8,9 on the page

following these figures

Fig. 43 - - Horizontal Left Application- -Vent Elbow Up

1. For common vent, vent connector sizing and vent material: United States- -- -use the NFGC.

2. Immediately increase to 5- -inch (127 mm) or 6- -inch (152 mm) vent connector outside furnace casing when 5- -inch (127 mm) vent connector is required, refer to Note 1

above.

3. Side outlet vent for upflow and downflow installations must use Type B vent immediately after exiting the furnace, except when factory- -authorized, Downflow Vent

Guard Kit, is used in the downflow position. See Product Data Sheet for accessory listing.

4. Type- -B vent where required, refer to Note 1 above.

5. Four- -inch single- -wall (26 ga. min.) vent must be used inside furnace casing and when the Downflow Vent Guard Kit is used external to the furnace. See Table NO TAG

for accessory listing.

6. Factory- -authorized accessory Downflow Vent Guard Kit required in downflow installations with lower vent configuration. See Product Data Sheet for accessory listing.

7. Chimney Adapter Kit may be required for exterior masonry chimney applications. Refer to Chimney Adapter Kit for sizing and complete application details. See

Product Data Sheet for accessory listing.

8. Secure vent connector to furnace elbow with (2) corrosion- -resistant sheet metal screws, spaced approximately 180_ apart.

9. Secure all other single wall vent connector joints with (3) corrosion resistant screws spaced approximately 120_ apart. Secure Type- -B vent connectors per vent connector

manufacturer's recommendations.

A03214

A03215

SEE NOTES: 1,2,4,5,7,8,9

Fig. 46 - - Horizontal Right Application- -Vent Elbow Left

VENTING NOTES FOR FIGURES 34 - - 46

SEE NOTES: 1,2,4,5,7,8,9 on the page

following these figures

Fig. 44 - - Horizontal Right Application- -Vent Elbow Left

SEE NOTES: 1,2,4,5,7,8,9 on the page

following these figures

Fig. 45 - - Horizontal Left Application- -Vent Elbow Right