Delay Start Button; Programme Option Buttons - Electrolux EWF 1229 Instruction Booklet

• Select programme
The water is emptied out without spinning.
• Select programme
Select the spin speed by means of the relevant
button and then depress the START/PAUSE
button . The water is emptied out and the
laundry is spun at the selected spin speed.
Attention! Before selecting programme
Spin or Delicate spin the
selector dial has to be positioned on O (Reset/Off).

5 Programme option buttons

Depending on the program, different functions can be
combined. These must be selected after choosing the
desired program and before depressing the
START/PAUSE button
When these buttons are pressed, the corresponding
pilot lights come on. When they are pressed again,
the pilot lights go out.
If an incorrect option is selected, the pilot lights flash
for about 2 seconds and the message Err is
displayed.
Press these buttons to select the following options:
PREWASH: select this option if you wish your
laundry to be prewashed before the main wash (not
available for wool, handwash and mini 30').
The Prewash ends with a short spin at 650 rpm in
programmes for cotton and synthetic fabrics,
whereas in the program for delicate fabrics the water
is only drained.
INTENSIVE : for heavy soiled laundry.
This option can be selected only for cottons and
synthetics.
The washing time will be prolonged according to the
cycle temperature and the fabric type.
EXTRA RINSE: this option can be selected with
all programmes, except the wool program and
handwash. The machine will add 2 rinses to all the
programmes.
This option is recommended for people who are
allergic to detergents, and in areas where the water is
very soft.
QUICK WASH: this option can be used for lightly
soiled laundry (not for wool, handwash, mini 30') in
order to obtain a good washing program in a short
time. The washing time will be reduced according to
the type of fabric and the selected temperature.
Drain:
Spin or Delicate spin.
Drain,
.

6 DELAY START button

The wash programme can be delayed from 30 min -
60 min - 90 min, 2 hours and then by 1 hour up to a
maximum of 23 hours by means of this button.
Selecting the delayed start
• Select the programme and the required options.
• Select the delay start.
• Depress START/PAUSE button
starts its hourly countdown.
The programme will start after the selected delay has
expired.
Cancelling the delayed start
• Depress START/PAUSE button
• Depress DELAY START button
displayed.
• Depress START/PAUSE button
7 DISPLAY
The display shows the following information:
Duration of the programme - Delayed start -
Incorrect option selection - Alarm code - End of
programme.
Duration of the selected
After selecting a programme, the duration is
displayed in hours and minutes ( for example 2.05).
The duration is calculated automatically on the basis of
the maximum recommended load for each type of
fabric.
After the programme has started, the time remaining
is updated every minute.
The selected delay (23 hours max) set by means of
the relevant button appears on the display for 3
seconds, then the duration of the previously
selected programme is displayed.
The countdown is updated every hour and when
remain the last 2 hours each 30 min.
80
: the machine
.
until «0'» is
again.
programme
Delayed start