Removing The Electronic Control; Removing The Delay Start Button; Removing The Interface Board; Removing The Selector Knob - Electrolux 6000 series Service Manual

6. Unplug the wiring harness from the control panel and
lift the panel off.

Removing the electronic control:

1. Disconnect the washer from the electrical supply
and remove the console.
2. Laythe console on a soft flat surface, remove the (5)
screws holding the control to the console.
3. Lift the control out of the console.

Removing the delay start button:

1. Disconnect the washer from the electrical supply
and remove the electronic control.
2. With the electronic control removed the delay start
button will lift out.

Removing the interface board:

1. Disconnect the washer from the electrical supply
and remove the electronic control.
2. With the electronic control removed the interface
board will lift out.

Removing the selector knob:

1. Disconnect the washer from the electrical supply
and remove the electronic control.
2. Using a pair of pliers squeeze the knob shaft and pull
the knob out the front of the control panel.
74