Abit KR7A User Manual page 68

4-4
When you choose to create RAID 1 and your source disk is not empty. You have to Duplicate Mirror
Disk to copy the data to the destination disk. Otherwise, it will only copy the partition table to the
destination disk, not the physical date.
Select Disk Drives:
This item allows you to select the disk drives to be used with the RAID array.
Stripe Size:
This item allows you to select the block size of the RAID array. There are five options: 4K, 8K, 16K, 32K,
and 64K.
Start Creation Process:
After you have made your selection, choose this item and press <Enter> to start creation.
4-3-2. OPTION 2: Delete RAID
This item allows you to remove a RAID Array on this IDE RAID controller card.
Note: After you have made and confirmed this selection, all the data stored in the hard disk will be lost.
(The entire partition configuration will be deleted too.)
4-3-3. OPTION 3: Rebuild Mirror Array
This item allows you to select the disk you wish to rebuild in preparation for a "Mirror Disk Array".
After you have selected the function you want in the main menu, you may press the <Enter> key to enter
the sub menu as shown below:
KR7A/KR7A-RAID
Note
Chapter 4