GE NX-148E User Manual page 20

Ready
Armed
System Ready
Type code to arm
ARMING AND DISARMING MULTIPLE PARTITIONS
To arm/disarm multiple partitions, enter a code that has arm/disarm authority for ALL
of the partitions to be armed/disarmed. The following display will appear on the LCD
screen.
12-45-78
--3 67-
LCD DISPLAY FOR AREA
TOP LINE OVER BOTTOM LINE
Blank
Blank
Dash (-)
Dash (-)
Flashing Area #
Dash (-)
Dash (-)
Flashing Area #
Area #
Dash (-)
Dash (-)
Area #
To disarm all of these areas, press • .
To arm all of these areas, press – .
To toggle a single area between the armed and disarmed conditions, press
[ ][Area number]. For example: If Area 4 is armed, [ ] [4] will disarm Area 4.
If Area 4 is disarmed, [ ] [4] will arm it.
Press [STAY] during the exit delay to bypass all interior zones in the exit delay.
To control the individual areas, refer to the following section.
18
12345678
1234-678
Disarm º
º
Arm
This display is reflecting all 8 areas are Ready,
and Area 5 is disarmed. NOTE: If a number is
flashing on the Armed line, that area is armed
Instant. If a number is flashing on the Ready
line, that area is ready to be Force Armed.
If ALL areas are disarmed and ready to arm,
this display will appear on the LCD screen.
The numbers on the top line represent the
disarmed areas to which this code has access.
The numbers on the bottom line represent the
areas that are armed. Refer to the following
table for possible conditions.
Area Not used or Authorized
Area Not Ready
Area Ready to Force Arm
Area Armed Instant
Area Disarmed & Ready to Arm
Area is Armed
CONDITION
NX-148E LCD Keypad