Part Names And Functions; Front Panel; Rear Panel - Denon PMA-710AE Owner's Manual

Part Names and Functions

For buttons not explained here, see the page indicated in parentheses ( ).

Front Panel

Q4 Q3 Q2
q w e r t y
q Power indicator
Changes as shown below according to PMA-
710AE's status.
• For several seconds after the power is turned
on · ·············································· Red (blinking)
• Power "ON" ············································Green
• Muting ······································· Red (blinking)
• Standby · ····················································· Red
• Power "OFF" ··············································· Off
w Power switch
(hON/STANDBY jOFF )
When set to "hON/STANDBY", the power turns
on, and when set to "jOFF", the power turns
off.
Headphones jack (PHONES)
e
r BASS control knob
TREBLE control knob
t
y BALANCE control knob
VOLUME control knob
u
i REC OUT SELECTOR knob
INPUT SELECTOR knob
o
Use this to select the source that you wish to
listen to.
Input indicator
Q0
The selected input is shown with an orange
indicator.
Q1
u i o
Q1 SOURCE DIRECT switch
When set to "hON", the signals do not pass
through the tone adjustment circuitry (bass,
treble, balance and loudness), resulting in
playback with higher sound quality.
When set to "jOFF", the sound can be
adjusted to your tastes.
LOUDNESS switch
Q2
When listening with the volume turned low, set
this to "hON" to amplify the bass and treble
sound that is hard to hear when the volume is
low and achieve a more natural sound.
Q3 SPEAKERS A/B switches
• When A (or B) is set to "hON", sound is
produced from the speakers connected to the
A (or B) speaker output terminals.
• When both A and B are set to "hON", sound is
produced from the speakers connected to both
the A and B speaker output terminals.
• When both A and B are set to "jOFF", no
sound is produced from the speakers. Use this
when listening over headphones.
Q4 Remote control sensor
VOLUME
• When the control knob is set just
beyond the "12 o'clock" position (over halfway),
the adjustments that can be made with the
TREBLE
and controls is decreased.
VOLUME
• When the control knob is set to
maximum or turned fully clockwise, the base and
treble can no longer be adjusted.
Q0

Rear Panel

u
q w
Input terminals (INPUTS)
q
Connect your source equipment here.
Recording input/output terminals
w
(RECORDER-1 and RECORDER-2)
Connect your recording equipment here.
PRE OUT terminals
e
Use this to add such equipment as a power
amplifier or subwoofer.
Speaker system terminals
r
(SPEAKER SYSTEMS)
Connect your speakers here.
AC OUTLETS
t
Use this as the power outlets for other audio
devices. Check equipment power requirement
ratings before use (see the ratings as marked
on the rear panel). If in doubt consult with your
dealer or DENON distributor.
NOTE
Functions r , t , y and Q2
SOURCE DIRECT
the switch is set to "jOFF".
BASS
e r t
Power cord
y
u SIGNAL GND (ground) terminal
Connect the ground wire from your turntable
here.
NOTE
• This terminal is not a safety ground.
• NEVER insert the short-circuiting pin plug into
the recording output or PRE OUT terminals.
Doing so could result in damage.
ENGLISH
are only available when
y