Fixture Cleaning; Troubleshooting - American DJ ROYAL 3D II User Instructions

Royal 3D II
Channel Value
1
0 - 7
8 - 15
16 - 239
240 - 247
248 - 255
2
0 - 7
8 - 15
16 - 239
240 - 247
248 - 255
3
0 - 127
128 - 189
190 - 193
194 - 255
4
0 - 127
128 - 189
190 - 193
194 - 255
5
0 - 7
8 - 23
24 - 39
40 - 55
56 - 71
72 - 87
88 - 103
104 - 119
120 - 135
136 - 151
152 - 167
168 - 183
184 - 199
200 - 215
216 - 231
232 - 247
248 - 255
ADJ Products, LLC - www.adj.com - Royal 3D II Instruction Manual Page 17
DMX Traits
Function
BLUE LASER
OFF
ON
STROBING SLOW - FAST
SOUND ACTIVE
ON
GREEN LASER
OFF
ON
STROBING SLOW - FAST
SOUND ACTIVE
ON
LASER ROTATION 1
0° - 360°
COUNTER - CLOCKWISE FAST - SLOW
NO ROTATION
CLOCKWISE SLOW - FAST
LASER ROTATION 2
0° - 360°
COUNTER - CLOCKWISE FAST - SLOW
NO ROTATION
CLOCKWISE SLOW - FAST
MACROS
NO FUNCTION
MACRO 1
MACRO 2
MACRO 3
MACRO 4
MACRO 5
MACRO 6
MACRO 7
MACRO 8
MACRO 9
MACRO 10
MACRO 11
MACRO 12
MACRO 13
MACRO 14
MACRO 15
SOUND ACTIVE
Royal 3D II
Locate and remove the unit's power cord. Once the cord has been
removed located the fuse holder located inside the power socket.
Insert a flat-head screw driver into the power socket and gently pry
out the fuse holder. Remove the bad fuse and replace with a new one.
The fuse holder has a built-in socket for a spare fuse be sure not to
confuse the spare fuse with active fuse.
Royal 3D II

Fixture Cleaning:

Due to fog residue, smoke, and dust cleaning
the internal and external lenses should be carried out periodically to
optimize light output.
1. Use normal glass cleaner and a soft cloth to wipe down the out-
side casing.
2. Clean the external optics with glass cleaner and a soft cloth every
20 days.
3. Always be sure to dry all parts completely before plugging the
unit back in.
Cleaning frequency depends on the environment in which the fixture
operates (I.e. smoke, fog residue, dust, dew). In heavy use we recom-
mend cleaning on a monthly basis. Periodic cleaning will ensure lon-
gevity, and crisp beam output.
Royal 3D II
Trouble Shooting: Listed below are a few common problems that
you may encounter, with solutions.
No laser output from the unit;
1. Be sure you have turned "ON" the unit.
2. Be sure the external fuse has not blown. The fuse is located on
the rear panel of the unit.
3. Be sure the fuse holder is completely and properly seated.
4. Be sure the unit is not in blackout mode.
Unit does not respond to sound;
1. Low frequencies (bass) should cause the unit to react to sound.
Tapping on the microphone, quiet or high pitched sounds may
not activate the unit.
ADJ Products, LLC - www.adj.com - Royal 3D II Instruction Manual Page 18
Fuse Replacement
Cleaning
Trouble Shooting