System Menu - American DJ ROYAL 3D II User Instructions

Royal 3D II
ADJ Products, LLC - www.adj.com - Royal 3D II Instruction Manual Page 11

System Menu

Royal 3D II
System Menu: When confirming your setting press ENTER
and then hold MENU for at least 2-3 seconds, or you can
wait 1 minute for automatic setup. To exit without making
any adjustments press the MENU button.
ADDR -
1. Press the MENU button until "ADDR" is displayed, press ENTER.
2. "X" will now be displayed, "X" represents the displayed address.
Press the UP or DOWN buttons to find your desired address.
3. Press ENTER to confirm, then connect your DMX controller.
NOTE: If after you connect your DMX controller the unit does not fall
into DMX mode, press and hold the MENU button for at least 3 sec-
onds.
SLND -
slave configuration.
1. Press the MENU button until "SLND" is displayed, press ENTER.
Either "SL 1" or "SL 2" will be displayed.
2. Press the UP or DOWN buttons until your desired setting is dis-
played, press ENTER to confim.
NOTE: In a Master/Slave configuration you can make one fixture the
Master and then set the next fixture to "SL 2", the fixtures will now
have contrast movement to each other.
SOUN
1. Press the MENU button until "SOUN" is displayed, press ENTER.
2. Either "ON" or "OFF" will now be displayed. Press the UP or DOWN
buttons to select one or the other.
3. When you have made your selection, press the ENTER, and then
press and hold the MENU button for at least 3 seconds to confirm.
DMX Address Setting via control board.
This will let you set unit as a slave in a master/
- In this mode you can run in sound active mode.
ADJ Products, LLC - www.adj.com - Royal 3D II Instruction Manual Page 12
System Menu