American DJ SWEEPER BEAM LED User Instructions page 7

Sweeper Beam LED
ENTER.
2. The display will show either "ON" or "OFF". Press the UP or
DOWN buttons to select "ON" to keep the LED display on at
all times, or "OFF" to switch to have the LED display switch off
after 10 seconds. To make the display reappear, press and hold
the MENU button for at least 5 secs.
3. Press ENTER to confirm. To make the display reappear, press
and hold the MENU button for at least 5 secs.
REV -
This function is used in conjuction with 11 Chan-
nel mode and 15 Channel mode. The direction in which the
projector lenses light up can be reversed so that the LED
line up can start at either end of the bar. This feature is
useful when the unit is installed in a reversed orientation so
the unit itself does not have to be uninstalled and reversed.
Example: When using 11 Channel mode, Channel 4 (LED 1) can
start at either end of the bar depending on this functions set up.
1. Press the MENU button until "REV" is displayed, press
ENTER.
2. The display will show either "YES" or "NO". Press the UP or
DOWN buttons to select "YES" which will have the projector
lenses light up right to left, or "NO" which will have the projec-
tor lenses light up left to right.
3. Press ENTER to confirm.
TILT -
This function activates tilt inversion.
1. Press the MENU button until "TILT" is displayed, press
ENTER.
2. The display will show either "YES" or "NO". Press the UP
or DOWN buttons to select "YES" to activate tilt inversion, or
ADJ Products, LLC - www.adj.com - Sweeper Beam LED User Manual Page 13
System Menu Sweeper Beam LED
"NO" to deactivate tilt inversion.
3. Press ENTER, and then press and hold the MENU button for
at least 3 seconds to activate.
DISP
1. Press the MENU button until "DISP" is displayed, press
ENTER.
2. Either "DISP" or "DSIP" will now be displayed. Press the
ENTER button to "flip" the display.
TEST
1. Press the MENU button until "TEST" is displayed, press
ENTER.
2. The fixture will now run a self test.
FHRS
time of the fixture.
1. Press the MENU button until "FHRS" is displayed, press
ENTER.
2. The running time of the fixture will now be displayed. Press
MENU to exit.
VER
ware of the fixture.
1. Tap the MENU button until "VER" is displayed, press ENTER.
2. The software version will now be displayed. Press MENU to
exit.
- This will "flip" the LED display 180º.
- This function will run a self test program.
- With this function you can display the running
- With this function you can display the version soft-
ADJ Products, LLC - www.adj.com - Sweeper Beam LED User Manual Page 14
System Menu