Using The Sleep Timer; Dimming The Display; Switching The Speaker Impedance; Checking Your System Settings - Pioneer VSX-AX4ASi-S Operating Instructions Manual

Using other functions

Using the sleep timer

The sleep timer switches the receiver into standby after a
specified amount of time so you can fall asleep without
worrying about the receiver being left on all night. Use
the remote control to set the sleep timer.
SLEEP
SR+
D.ACCESS
+10
AV PARAMETER
• Press SLEEP repeatedly to set the sleep time.
30 min
Off
• You can check the remaining sleep time at any time
by pressing SLEEP once. Pressing repeatedly will
cycle through the sleep options again.

Dimming the display

You can choose between four brightness levels for the
front panel display. Note that when selecting sources,
the display automatically brightens for a few seconds.
SLEEP
SR+
D.ACCESS
+10
AV PARAMETER
• Press DIMMER repeatedly to change the brightness
of the front panel display.

Switching the speaker impedance

We recommend using speakers of 8 Ω with this system,
but it is possible to switch the impedance setting if you
plan to use speakers with a 6 Ω impedance rating. Use
the front panel controls to do this.
• With the receiver in standby, press
ON while holding down the SPEAKERS button.
Each time you do this, you switch between the
impedance settings:
• SP 6 OHM – Use this setting if your speakers are
rated at 6 Ω.
• SP 8 OHM – Use this setting if your speakers are
rated at 8 Ω or more.
Note
1 You can also switch off the sleep timer simply by switching off the receiver.
2 If the Pure Direct mode is switched on, some settings above will show OFF, even though they are on.
VIDEO ANALOG
SEL ATT
DIMMER S.RETRIEVER
CLASS
DISC
ENTER
CH LEVEL
60 min
90 min
1
VIDEO ANALOG
SEL ATT
DIMMER S.RETRIEVER
CLASS
DISC
ENTER
CH LEVEL
STANDBY/

Checking your system settings

Use the status display screen to check your current
settings for features such as surround back channel
processing and your current MCACC preset.
AUDIO SUBTITLE
DISP
STATUS SIGNAL SEL
MULTI OPE THX
SHIFT
PHASE
1 Press STATUS to check the system settings.
These appear on both the OSD and the front panel
2
display.
STATUS
96kHz STEREO
Signal Select
SBch Processin : OFF
Retriever
Video Select
MCACC Position : M1
Room2/REC SEL : SOURCE
Room3
The front panel display shows each of the following
settings for two seconds each:
Input source
Signal select
Sound Retriever
MCACC Position
Room 3
2 When you're finished, press STATUS again to
switch off the display.
HDD DVD
CH CH
PHOTO
SBch STEREO
STANDARD ADV. SURR
MCACC S.DIRECT
: AUTO
: ON
: OFF
: SOURCE
Listening mode
Surround Back Processing
Video Select
Room 2 / REC SEL
10
69
En