Cub Cadet GT 2554 Operator's Manual page 22

CONTROL
CAM
1. Front Control Rod
2. Rear Control Rod
3. Hex Tap Screw
4. Hex Wash Hd Tapp Screw
5. Control Arm
6. Control Arm Pin
7. Neutral Arm
8. Centering Pin
9. Neutral Return Adjust. Brkt.
10. Internal Cotter Pin
Adjusting the Control Rod
After completing the previous steps (1 thru 4) for
checking neutral setting, refer to Figure 16 and adjust
the control rod as follows:
NOTE: The brake pedal lock MUST be engaged to
properly adjust the control rod.
1. Loosen, but do not remove, the hex tap screws (3)
that fasten the front and rear control rods together.
2. While making certain to not move the front control
rod (1), control cam, or control arm (5), slide the
rear control rod (2) in the direction necessary to
directly align its hole with the control arm pin (6).
3. Slide the rear control rod onto the control arm pin
and secure with the internal cotter pin (10), then
tighten the hex tap screws(3). Make sure to
maintain the adjusted position of the control rods
when tightening the screws.
4. Raise the rear of the tractor, remove the jack
stands and lower the tractor.
3
2
1
9
7
Figure 16
ADJUSTING LIFT ASSIST SPRING TENSION
The effort required to operate the implement lift handle
can be varied by loosening or tightening the lift assist
spring adjusting bolts on each side of the tractor (See
Figure 17). The bolts can be accessed from the rear of
the tractor, inside the left and right rear wheels. Turning
each adjusting bolt clockwise will decrease the manual
effort
counterclockwise will increase the effort needed to lift
the attachment. It is recommended that both lift assist
springs be adjusted to approximately the same tension.
22
10
4
5
6
8
required for lifting
LEFT LIFT
ASSIST SPRING
Figure 17
7
attachments; turning
ADJUSTING
BOLT