Table of Contents
Advertisement
Charging the Battery
Test and, if necessary, recharge the
battery after the tractor has been
stored for a period of time.
• A voltmeter or load tester should
read 12.6 volts (DC) or higher
across the battery terminals.
• Charge the battery with a 12-volt
battery charger at a MAXIMUM rate
of 10 amps.
Voltmeter
State of
Reading
Charge
12.7
100%
12.4
75%
12.2
50%
12.0
25%
Headlight Bulb Replacement
Replace
headlight bulbs as follows:
(See Figure 20)
1.
After noting which wire connects
to each terminal, unplug the wire
harness leads from the headlight
socket terminals.
2.
Rotate the socket assembly as
follows
to
reflector housing:
Socket Tab
Figure 20
• Left headlight — approximately 1/
4 turn counterclockwise.
• Right headlight — approximately
1/4 turn clockwise.
Charging
Time
Full Charge
90 Min.
180 Min.
280 Min.
remove
from
Terminals
Socket
Reflector Housing
Reflector Notch
3.
Push the bulb inward and turn
counterclockwise to remove from
the socket.
4.
Align the post of the bulb base
with the notch in the socket, then
push the bulb inward and turn
clockwise to lock
5.
With
upward, align the tab of the
socket with the notch of the
reflector. Push the socket inward
and turn as follows to lock:
• Left headlight-1/4 turn clockwise.
• Right headlight-1/4 turn counter-
clockwise.
6.
Connect the wire harness leads to
the appropriate socket terminals.
Tire Inflation
Keep
the
recommended
inflation will affect tire life and operator
comfort, and also could affect the level
of the mower deck and quality of cut.
See the tire side wall for proper
inflation range.
Ensure that the valve caps are
the
securely tightened in place to prevent
air loss and to protect the valve core.
Do not overload the tractor tires by
mounting equipment on the tractor
which exceeds the load capacity of the
size of the tires on the tractor.
Checking Transmission Oil Level
NOTE: Check the oil level only while
the engine is stopped and the tractor
is level.
Check the oil level of the transmission
case before each use to see that it is
filled to the correct level. Before
checking the transmission oil level,
clean
the
Transmission
prevent debris from entering the
transmission case. Always keep the oil
level between the "FULL" and the
"ADD" marks on the dipstick. When
checking the oil level, the dipstick
must be withdrawn and wiped clean,
27
the
terminals
tires
inflated
pressure.
area
around
Oil
Fill/Dipstick
pointing
to
the
Improper
the
to
Hide quick links:
Advertisement
Table of Contents
