Safety Labels Found On Your Unit - Cub Cadet GT 3100 Operator's Manual

SECTION 5: SAFETY LABELS FOUND ON YOUR UNIT
DECK HEIGHT
ADJUSTMENT
(360 Turn Equals 1/2" Adjustment)
RAISE DECK LIFT LEVER UNTIL THE
1.
NUMBER 6 APPEARS IN WINDOW.
POSITION INDICATOR
2.
TURN KNOB COUNTER CLOCKWISE
TO LOWER DECKSTOP.
3. TURN KNOB CLOCKWISE TO RAISE
DECKSTOP.
4. LOWER DECK LIFT LEVER UNTIL
POSITION INDICATOR STOPS.
5.
REPEAT PROCESS IF NECESSARY.
Running Board - Left
STARTING INSTRUCTIONS
1. BE FAMILIAR WITH CONTROLS
BEFORE STARTING ENGINE AND
OPERATING.
2. SET CHOKE, MOVE THROTTLE TO MID
POSITION AND DEPRESS BRAKE PEDAL.
3. TURN KEY TO THE START POSITION.
4. AFTER ENGINE STARTS OPEN CHOKE.
STOPPING INSTRUCTIONS
1. DISENGAGE PTO AND SET PARKING
BRAKE.
2. MOVE THROTTLE CONTROL TO MID
POSITION AND TURN KEY OFF.
OPERATING MODES
NORMAL MOWING
YOU MUST DISENGAGE BLADES/PTO,
(POWER TAKE OFF) BEFORE TRAVELING
IN REVERSE.
REVERSE
CAUTION MODE
TURN KEY TO REVERSE CAUTION
1
.
MODE POSITION.
2 DEPRESS REVERSE PUSH BUTTON.
.
(RED INDICATOR LIGHT "ON")
WHEN RED LIGHT IS "ON" MACHINE
CAN BE OPERATED IN REVERSE WITH
MOWER BLADES ENGAGED.
IMPORTANT: MOWING IN REVERSE IS
NOT RECOMMENDED.
3. AFTER RESUMING FORWARD OPERATION,
RETURN KEY TO "NORMAL MOWING"
POSITION.
NOTE: IN BOTH MODES, WHEN OPERATOR
LEAVES SEAT, ENGINE WILL STOP UNLESS
PARKING BRAKE IS SET AND BLADES ARE
DISENGAGED.
Running Board - Center
WARNING
TO ENSURE SAFE AND
PROPER OPERATION
OF TRANSMISSION,
ONLY USE CUB CADET
DRIVE SYSTEM
FLUID PLUS.
737-3120 - 1 QUART
737-3121 - 1 GALLON
READ OPERATOR'S
MANUAL
Rear Drawbar
Hood Hinge Bracket
WARNING
HOT AREAS
!
Front Grille
Figure 2
10
DANGER
ROTATING BLADES CAUSE
SERIOUS INJURY OR DEATH
DO NOT MOW WHEN
•
CHILDREN OF OTHERS
ARE AROUND.
NEVER CARRY
•
CHILDREN EVEN
WITH BLADE(S) OFF.
LOOK DOWN AND
•
BEHIND BEFORE AND
WHILE BACKING.
MOWING IN REVERSE
•
IS NOT RECOMMENDED.
WARNING
AVOID SERIOUS INJURY
OR DEATH
GO UP AND DOWN SLOPES, NOT
•
ACROSS.
AVOID SUDDEN TURNS.
•
DO NOT OPERATE UNIT WHERE
•
IT COULD SLIP OR TIP.
IF MACHINE STOPS GOING
•
UPHILL, STOP PTO AND BACK
DOWN HILL SLOWLY.
KEEP SAFETY DEVICES [GUARDS,
•
SHIELDS, AND SWITCHES] IN
PLACE AND WORKING.
REMOVE OBJECTS THAT COULD
•
BE THROWN BY THE BLADES.
KNOW LOCATION AND FUNCTION
•
OF ALL CONTROLS.
BE SURE THE BLADES AND THE
•
ENGINE ARE STOPPED BEFORE
PLACING HANDS OR FEET NEAR
BLADES.
BEFORE LEAVING OPERATOR'S
•
POSITION, DISENGAGE PTO,
ENGAGE BRAKE LOCK, SHUT
OFF ENGINE AND REMOVE KEY.
READ OPERATOR'S
MANUAL
Running Board - Right
Key Switch/Module -
Dash Panel