Changing The Port Settings For Smartdevicemonitor For Client - Savin MLP28 Operating Instructions Manual

Preparing for Printing

Changing the Port Settings for SmartDeviceMonitor for Client

Follow the procedure below to change the SmartDeviceMonitor for Client set-
tings, such as TCP/IP timeout, recovery/parallel printing, and printer groups.
❒ There are no settings for NetBEUI protocol.
Windows 95/98:
A
Open [Printers] window from [Start] menu.
B
In the [Printers] window, click the icon of the printer you want to use. On
the [File] menu, click [Properties].
C
Click the [Details] tab, and then click [Configure Port].
The [Port Settings] dialog box appears.
Windows 2000 / Windows NT 4.0:
A
Open [Printers] window from [Start] menu.
B
In the [Printers] window, click the icon of the printer you want to use. On
the [File] menu, click [Properties].
C
On the [Ports] tab, click [Configure Port].
The [Port Settings] dialog box appears.
Windows XP, Windows Server 2003:
A
On the [Start] menu, point to [Settings], and then click [Printers].
B
In the [Printers] window, click the icon of the printer you want to use. On
the [File] menu, click [Properties].
C
Click the [Details] tab, and then click [Configure Port].
The [Port Settings] dialog box appears.
• For TCP/IP, timeout setting can be configured.
❒ If no settings on the [Recovery/Parallel Printing] tab are available, follow
the procedure below.
A Click [Cancel] to close the [Port Configuration:] dialog box.
B
Start SmartDeviceMonitor for Client, and then right-click the Smart-
DeviceMonitor for Client icon on the taskbar.
37