Casio Privia PX-5S User Manual page 28

Sounding Arpeggios Automatically (Tutorial)
4.
Change the TYPE, NOTE, VELO, and CTRL settings as desired.
• While [TYPE] is selected, use the
and tie* (TIE). Note, however, that "STEP 01" does not have a TIE option.
* Selecting TIE extends the duration of the previous step by one step. It can be used to extend the duration of notes.
• NOTE and VELO settings cannot be configured for a step whose TYPE setting is Off or TIE.
• The table below shows the settings on the arpeggio step editing menu.
Menu Level
1
Step Edit >Ent
TYPE
NOTE
VELO
CTRL
5.
After the TYPE, NOTE, VELO, and CTRL values are the way you want, press the
return to the "ARPEGGIO" menu.
E-26
Step type
eo minus (–) and plus (+) buttons to cycle the TYPE setting between off (Off), on (TYPE)
2
Specifies what note of the arpeggio should be
played in the currently selected step, in relation to
the lowest note (L1) of the keyboard keys pressed.
• If the value specified for a step is greater than the
number of keyboard keys pressed, the
corresponding notes of the arpeggio will be
played one octave higher. For example, if L4 is
specified here, pressing only three keyboard
keys will play L1, one octave higher.
• After one octave, the corresponding note will
return back to the original octave.
Specifies what note of the arpeggio should be
played in the currently selected step, in relation to
the highest note (U1) of the keyboard keys pressed.
• If the value specified for a step is greater than the
number of keyboard keys pressed, the
corresponding notes of the arpeggio will be
played one octave lower. For example, if U4 is
specified here, pressing only three keyboard
keys will play U1, one octave lower.
• After one octave, the corresponding note will
return back to the original octave.
Specifies what note should be played in the
currently selected step, in relation to the highest
note of the keyboard keys pressed.
• If the number of keys pressed is less than the
value specified here, the arpeggio is played only
up to the keys pressed.
Specifies a shift of the note sounded, in semitone
steps, from the notes of the keys played on
keyboard.
Changes the velocity (volume level) of the
keyboard keys that are pressed.
This setting can be used to change the control type
value selected with the arpeggio parameter editing
menu in step 7 of this procedure, below.
Step number
Description Setting
L1 to L8
U1 to U8
P2 to P5
–24 - 0 - +24
–64 - 0 - +63
Bend: –128 to 0 to +127,
Pan (Control Change 10):
–64 to 0 to +63,
Control Change 00 to 97
(except for Pan):
0 to 127
dr (EXIT) button to