Basic Installation Procedures; Requirements For Installing The Gateway - Siemens SIMATIC TI500 User Manual

Basic Installation
Procedures
Requirements for
Installing the
Gateway
TIWAY I Gateway User Manual
Some basic procedures to follow when installing a Gateway system include
the following.
Be sure you have all components necessary to install the Gateway and
the network cables. (Refer to the checklist below for required parts.)
Install the TIWAY I network and host system interface cables (see
Section 2.2). Also refer to the appropriate host system installation
manuals for specific information on cabling between the host and the
Gateway.
Install the Gateway in a NEMA panel or other suitable enclosure (see
Chapter 3 for more details).
The items below are required to install the TIWAY I Gateway and to connect
it to a host system and the TIWAY I network.
TIWAY I Gateway
L-shaped mounting brackets and bracket screws, or optional rack
mount kit.
Host interface cable (included; PPX:2462553–0003)
Mounting screws (customer-supplied)
AC power cable (customer-supplied)
Loopback connector(s) for user-initiated diagnostic test (included;
PPX:2703834–0001)
TIWAY I Tap Housing (for Local Line installation) (PPX:500–5606)
Tap cable for use with Local Line (customer-supplied), or
RS-232-C/423 cable for use with modems (both cables and modems are
customer-supplied)
Network Installation 2-3