Arming The System While People Stay At Home; Disarming The System, Stopping And Resetting Outgoing Alarms; How To Arm Partitions - Siemens IC60 User Manual

3.7

Arming the system while people stay at home

3.8

Disarming the system, stopping and resetting outgoing alarms

3.9

How to arm partitions

Building Technologies
Fire Safety & Security Products
Used keys:
<STAY>
Arming the System in Stay Mode
This type of arming is used when people are present within the protected area.
Consequently, interior movements will be ignored by the system.
1. Press <STAY>.
2. Enter your CODE.
3. Press <ENTER>
The STAY indicator flashes indicating that the system is now armed in stay
mode.
Quick Stay
This feature must be enabled at installation time.
1. Press <STAY> to arm the system.
The system is armed immediately.
The <STAY> indicator indicates that the system is armed in stay mode.
The indicators may go out few seconds after exit delay times out, depending on the installation
setting.
To disarm the System
1. Press disarm on your remote Control
or
1. Enter the User PIN code
2. Press <ENTER>
The <ARM>/ <STAY> indicator goes off, the system is now disarmed.
This stops the alarm at any time, and also turns off any audible sirens.
Outgoing signals are stopped
CODE
<ARM>
The protected area can be grouped into two separate partitions (A or B). The sys-
tem can be grouped for the user's convenience to separate e.g. the offices from
the warehouse area in a business environment, or the different rooms of a private
residence, e.g. living room, bedroom, etc.
PIN
PIN <ENTER>
Using the system
11
08.2007