Table of Contents
Advertisement
HOW TO OPEWTE YOUR DRYER
WARNINGTO reduce the risk of fire, electric shock, or injury to persons when using your
appliance, read the IMPORTANT SAFETY INSTRUCTIONS before operating this appliance.
to Operate Your Washer section for the above Washer controls.
How
Check the Lint Filter
Clean the lint filter each time the dryer is used.
Always be sure the lint filter is in place.
A
Do not run the dryer with the lint screen
loose, damaged, blocked or missing. Doing
so can cause overheating, damage fabrics
and be a fire hazard.
The lint screen is located inside
the dryer drum, on the back wall.
To clean:
1. Use the finger holes to pull
the lint screen straight out.
2. Lightly squeeze the body,
shown while pulling the cover off.
as
Sort and Load the Clothes
Good sorting for the dryer begins at the washer.
Generally, if clothes are sorted right for washing,
they're sorted right for drying. See the How to Sort
the Clothes section.
Set the Controls
See the Suggested Fabric and Drying Selections guide.
Turn the Cycle Selector to the desired cycle setting.
The selector may be turned in either direction.
NOTE: Drying times will vary according to the type of heat used (electric,
natural gas or LP gas), size of load, types of fabrics, wetness of clothes and
condition of exhaust ducts.
14
Load Size
. . . . ... . . . . . . .
. . . \
. . . . . . . . . . . . —
. .. . ... . . . . . . . .
. . . .:.
.. . ... . .
. . . . . . .
.. . .
.
. /
PULL STRAIGHT OUT
,
3. ROLL lint off the screen with
your fingers. Do not
wash the screen.
4. Replace the cover
the body
on
of the lint screen.
5. Before replacing the lint
screen, remove any lint from
the wire mesh on the back
wall (behind the lint screen).
6. Push the lint screen straight
back until it snaps into place.
If you do mix various types of fabrics in your load,
set the controls for the lighter-weight fabrics and
remove when dry. Reset controls for the remaining
heavier fabrics.
Press the Start button to start the dryer. (Opening
the door during operation stops the dryer. To
restart, close the door and press the Start button.)
I
\
1"
SQUEEZE BODY;
PULL COVER OFF
Advertisement
Table of Contents
