Panasonic AK-HC3800G Operating Instructions Manual page 10

Parts and their functions
8.
Camera power switch <POWER>
Use this to select the camera power input (power supplied from the
CCU or from an external power supply input connector <DC IN>) and
turn the power OFF.
CCU : When connecting this unit to the CCU, supply
power from the CCU and turn the power ON.
EXT : When connecting the external DC power supply
to this unit, supply power from the external power
supply and turn the power ON.
Middle position : Turn the power OFF.
9.
Power LED
This lights up green when power is supplied to the camera.
Green light ON : The camera power is ON
Red light ON : The camera power is OFF while connected to the
CCU whose power is ON
Light OFF : The camera power is OFF while not connected to
the CCU, or while connected to the CCU whose
power is OFF
10.
INCOM connector <INCOM>
Connect the intercom or headset plug here.
11.
INCOM MIC ON/OFF switch <TALK>
This is the intercom microphone ON/OFF/PTT selector switch.
When using the Push-to-Talk (PTT) intercom or headset, set the
switch to the PTT side to turn on the microphone.
12.
INCOM level control <LEVEL>
This is used to adjust the volume level of the intercom when the
intercom and PGM mixing function is set to ON.
The intercom and PGM mixing function can be set to ON or OFF on
the camera menu.
[USER MENU] > [OPERATION] > [MIC/INCOM SETTING] >
[PGM MIX]
13.
INCOM/PGM level control <PGM>
This is used to adjust the intercom and PGM mixing level.
14. CALL LED
This lights up green when the CALL switch is pressed from the ROP
or CCU.
15.
CALL switch <CALL>
While this switch is pressed, the CALL LEDs on the ROP and CCU
are lit and the buzzer on the ROP sounds. (When the buzzer setting
of the ROP is ON)
10
(continued)
18 17
9 8
14 16
OPT
CALL
15
PGM
11
LEVEL
TALK
ON
OFF
PTT
INCOM
10
FRONT +48V +48V
OFF OFF
REAR
AB AB
DC OUT
12V 1A
LINE MIC LINE MIC
RET
CTRL
DC IN
PROMPTER
OUT
MIC 1 MIC 2
16.
OPT LED
This indicates the camera's optical signal reception status.
Normal : Green light ON
Error : Red light ON
<Note>
When an error occurs, turn off the power of this unit and the CCU
and then clean the optical fiber connector. If the error is not cleared,
immediately turn off the power, and contact your dealer.
17.
Back tally LED selector switch
Use this to set the back tally LED to ON or OFF.
18.
Back tally LED
This lights when the tally signal is supplied.
R tally signal: Red light ON
G tally signal: Green light ON
R and G tally signals at the same time: Red light ON
13
12