Front Panel Display Messages - Pioneer LX03 Operating Instructions Manual

Additional information

Front panel display messages

Message
192kHz PCM
2ch Only
96kHz PCM
Error MIC!
Error Speaker!
Exit
HDMI Audio <TV>
HDMI C.ERR 1**
HDCP ERROR
Key Lock
Line Out Mode
Muting
No MIC
Noisy!
Not support
OC Error1
OC Error2
Over Temp
Phones In
Tray Lock
USB Error
*** BackUpERR
Description
An operation is prohibited because the source is 176.4 kHz/192 kHz PCM.
An operation is prohibited because it is only applicable to 2 channel sources, while
the current source is a multichannel source.
An operation is prohibited because the source is 88.2 kHz/96 kHz PCM.
An error occurred during MCACC setup because the microphone is not connected
or is not connected properly.
An error occurred during MCACC setup because the speakers are not connected or
are not connected properly.
Appears when a menu is automatically exited after a set period of inactivity.
Displays when you change the listening mode, the volume level, or some sound
HDMI Audio is set to TV
settings when the
Check if the HDMI cable is properly connected. If the cable is properly connected,
this unit may be damaged. In such an event, please contact a Pioneer-authorized
service center or your nearest dealer.
Check whether or not the connected component is compatible with HDCP. If it is not
compatible with HDCP, reconnect the source device using a different type of
connection (SCART or composite). Some components that are compatible with
HDCP still cause this message to be displayed, but so long as there is no problem
with displaying video, this is not a malfunction.
The key lock is enabled. See Key lock setting on page 70.
Operation is disabled since Line Output is set to Lt/Rt.
When audio is muted, display appears if Auto MCACC setup is performed.
Display appears when Auto MCACC setup is performed without a microphone
connected.
Background noise is too high to complete MCACC setup successfully.
For HDMI1 or 2 inputs:
Try adjusting the resolution, DeepColor or other setting for your component.
For DVD input:
Try changing the resolution in the HDMI Resolution setting (page 54).
Check whether the speaker cables are short-circuited. If the error message continues
to be displayed, contact your Pioneer authorized service center or your dealer for
servicing.
Try lowering the volume. If this problem is not fixed by removing and inserting the
power cable, this unit may be damaged. In such an event, please contact a Pioneer-
authorized service center or your nearest dealer.
An operation is prohibited because the headphones are connected.
The tray lock is on (see page 80).
See Important on page 43 for more on this.
Contact your Pioneer authorized service center or your dealer for servicing.
.
14
83
En