Pioneer LX03 Operating Instructions Manual page 14

02 Connecting up
Match the color-coded wire with the color
indicator on the label, then insert the color-
coded wire into the red (+) side and the
other wire into the black (–) side.
Black (–) Red (+)
• When connecting the center speakers,
connect the Y-cable dual end to the two
center speakers in the same way.
• Connect the other end to the color-coded
speaker terminals on the rear of the
receiver. Make sure to insert completely.
The small lug at the wire-end of the speaker
plug should face up or down depending on
whether it's being plugged into one of the
upper or lower speaker terminals. Please
make sure to connect correctly.
Upper terminal
14
En
Color-coded wire
Y-cable
To receiver
Lower terminal
• Fasten the cables together with the spiral
wrap.
Hold multiple cables together and place
the wrap over the cables from the end.
Wrap the spiral wrap with the cables in the
center.
The spiral wrap may be cut at a desired
length.
Caution
• These speaker terminals carry
HAZARDOUS LIVE voltage. To prevent
the risk of electric shock when connecting
or disconnecting the speaker cables,
disconnect the power cord before touching
any uninsulated parts.
• Do not connect any speakers other than
those supplied to this system.
• Do not connect the supplied speakers to
any amplifier other than the one supplied
with this system. Connection to any other
amplifier may result in malfunction or fire.
• After connecting the plugs, pull lightly on
the cables to make sure that the ends of
the cables are securely connected to the
terminals. Poor connections can create
noise and interruptions on the sound.
• If the cable's wires happen to be pushed
out of the terminals, allowing the wires to
come into contact with each other, it
places an excessive additional load on the
amp. This may cause the amp to stop
functioning, and may even damage the
amp.