Dvd/Cd/Video Cd Player - Pioneer LX03 Operating Instructions Manual

14 Additional information
Problem
Can't operate using the
remote control.
The front panel display
and indicators do not
appear.
Motion sensor not
working.
Tray Lock shows in the
display and the tray can't
be ejected.

DVD/CD/Video CD player

Problem
The disc is ejected
automatically after
loading.
Playback not possible.
Picture playback stops
and buttons cannot be
used.
Settings are canceled.
80
En
Remedy
• Replace the batteries (see Putting the batteries in the remote control on page 21).
• Operate within 7 m, 30° of the remote sensor (see Using the remote control on
page 21).
• Remove any obstacles or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
• Check that there's nothing mistakenly plugged into the CONTROL IN jack.
• For operating the other Pioneer component connected to the CONTROL OUT
jack of this unit, make sure that the control cable and either an HDMI or analog
audio cable are connected (page 62).
• If an object is placed on top of the touch sensor, the sensor will be activated,
thus disabling the remote control unit operations. If the action indicator remains
continuously lighted, remove any object sitting on the touch sensor panel.
• If the display mode is set to Auto Display, the display will automatically turn off
if no operation is performed for a period of one minute. Try performing an
operation.
• The motion sensor is on the front of the unit. Make sure you are within 2.5 m and
40° of the sensor.
• Since the motion sensor uses infrared rays, it may not work correctly if placed in
direct sunlight or close to heat source.
• Minimum unit height must be 25 cm or above from ground level. The sensor will
not work properly when located at ground level.
• Motion sensor will not work if placed in a fully sealed cabinet (include glass /
clear cabinet).
• Press and hold  OPEN/CLOSE on the front panel for about eight seconds. Then
the tray can be opened/closed using  OPEN/CLOSE.
Remedy
• Clean the disc and align the disc properly in the disc guide.
• If the region number on a DVD-video disc does not match the number on the
player, the disc cannot be used (see DVD Video regions on page 76). In this
instance, the following message appears on screen: Incompatible disc region
number/Can't play disc.
• Allow time for any condensation inside the player to evaporate. Avoid using the
player near an air-conditioning unit.
• If the disc is loaded upside down, reload the disc with label side face up.
• Press  (stop), then  (play) to start playback again.
• Switch the power off once, then on again using the front panel  STANDBY/ON
button.
• When the power is cut, settings will be canceled.