Replacing The Fuse - Yamaha Giggle XF50E Owner's Manual

Fuse, replacing<IXE>
● ● ● ● ●
To charge a sealed-type (MF)
battery, a special (constant-volt-
age) battery charger is required.
Using a conventional battery
charger will damage the battery.
If you do not have access to a
sealed-type (MF)
charger, have a Yamaha dealer
charge your battery.
● ● ● ● ●
After installing the battery, be
sure to turn the main switch
from "ON" to "OFF" three times
in 3 seconds intervals to initial-
ize the idle speed control sys-
tem.
PERIODIC MAINTENANCE AND MINOR REPAIR

Replacing the fuse

battery
ZAUM00**
1. Fuse
The fuse holder is located beside the
battery. Remove panel C to access the
fuse. (See page 6-6.)
If the fuse is blown, replace it as follows.
1. Turn the key to "OFF" and turn off
all electrical circuits.
2. Remove the blown fuse, and then
install a new fuse of the specified
amperage.
Specified fuse:
15 A
EAUT2021
cC
1
3. Turn the key to "ON" and turn on
4. If the fuse immediately blows again,
6-21
● ● ● ● ●
Do not use a fuse of a higher
amperage rating than recom-
mended to avoid causing exten-
sive damage to the electrical
system and possibly a fire.
● ● ● ● ●
After removing and installing the
main fuse, be sure to turn the
main switch from "ON" to "OFF"
three times in 3 seconds inter-
vals to initialize the idle speed
control system.
the electrical circuits to check if the
devices operate.
have a Yamaha dealer check the
electrical system.
EAU17226
ECAT1061
1
2
3
4
5
6
7
8
9