Yamaha Giggle XF50E Owner's Manual page 40

PERIODIC MAINTENANCE AND MINOR REPAIR
1
1
2
3
ZAUM00**
1. Engine oil filler cap
4
2. Maximum level mark
3. Minimum level mark
5
3. Wait a few minutes until the oil
settles, remove the oil filler cap,
wipe the dipstick clean, insert it
6
back into the oil filler hole (without
screwing it in), and then remove it
7
again to check the oil level.
NOTE:
8
The engine oil should be between the
minimum and maximum level marks.
9
4. If the engine oil is below the mini-
mum level mark, add sufficient oil
of the recommended type to raise
it to the correct level.
5. Insert the dipstick into the oil filler
hole, and then tighten the oil filler
cap.
To change the engine oil and clean
the oil strainer
1. Start the engine, warm it up for sev-
2
eral minutes, and then turn it off.
3
2. Place an oil pan under the engine
to collect the used oil.
3. Remove the engine oil filler cap and
the engine oil drain bolts A and B
to drain the oil from the crankcase.
1
ZAUM00**
1. Engine oil drain bolt A
6-8
1
ZAUM00**
1. Engine oil drain bolt B
cC
When removing the engine oil drain
bolt B, the O-ring, compression
spring, and oil strainer will fall out.
Take care not to lose these parts.
4. Clean the oil strainer with solvent,
and then check it for damage and
replace it if necessary.
5. Check the O-ring for damage and
replace it if necessary.
6. Install the oil strainer, compression
spring, O-ring and engine oil drain
bolt B.
EAU17226
ECAT1020