Yamaha MAJESTY 400 Owner's Manual page 26

INSTRUMENT AND CONTROL FUNCTIONS
Right
1
2
3
1. Engine stop switch "
4
2. Hazard switch " "
3. Start switch " "
5
6
Pass switch "PASS"
Press this switch to flash the headlight.
7
Dimmer switch "
8
Set this switch to "
beam and to " " for the low beam.
9
Turn signal switch "
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
leased, the switch returns to the center
position. To cancel the turn signal
1
lights, push the switch in after it has re-
turned to the center position.
Horn switch "
Press this switch to sound the horn.
2
3
Engine stop switch "
Set this switch to "
/ "
the engine. Set this switch to "
stop the engine in case of an emergen-
cy, such as when the vehicle overturns
or when the throttle cable is stuck.
EAU12360
Start switch "
With the sidestand up, push this switch
EAU12400
while applying the front or rear brake to
/ "
crank the engine with the starter.
" for the high
CAUTION:
See page 5-1 for starting instruc-
EAU12460
tions prior to starting the engine.
/ "
". When re-
(for ABS models)
The engine trouble warning light and
ABS warning light will come on when
the key is turned to "ON" and the start
EAU12500
"
switch is pushed, but this does not indi-
cate a malfunction.
EAU12660
/ " Hazard switch "
" before starting With the key in the "ON" or "
" to tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
turn signal lights).
The hazard lights are used in case of
an emergency or to warn other drivers
EAU12720 when your vehicle is stopped where it
"
might be a traffic hazard.
CAUTION:
Do not use the hazard lights for an
ECA10050
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
3-10
EAU42810
EAU12733
"
" posi-
ECA10061