Replacing The Fuse; Replacing The Headlight Bulb - Yamaha SLIDER EW50N Owner's Manual

Replacing the fuse

1
3
ZAUM0162
1. Panel A
2. Fuse
3. Battery
The fuse holder is located behind panel
A. (See page 6-6.)
If the fuse is blown, replace it as fol-
lows.
1. Turn the key to " " and turn off all
electrical circuits.
2. Remove the blown fuse, and then
install a new fuse of the specified
amperage. WARNING! Do not
use a fuse of a higher amperage
rating than recommended to
avoid causing extensive dam-
age to the electrical system and
possibly a fire.
[EWA15131]
PERIODIC MAINTENANCE AND ADJUSTMENT
EAU23503
Specified fuse:
7.5 A
3. Turn the key to "
the electrical circuits to check if the
devices operate.
2
4. If the fuse immediately blows
again, have a Yamaha dealer
check the electrical system.

Replacing the headlight bulb

If the headlight bulb burns out, replace
it as follows.
" and turn on
NOTICE
It is advisable to have a Yamaha
dealer perform this job.
1. Remove cowling A. (See page
2. Disconnect the headlight coupler.
3. Remove the headlight bulb holder
ZAUM0899
1. Headlight bulb holder
4. Place a new headlight bulb into po-
5. Connect the coupler.
6-21
6-6.)
by turning it counterclockwise, and
then remove the burnt out bulb.
sition, and then secure it with the
bulb holder.
EAUM2111
ECA10670
6
1