Table of Contents
Advertisement
Chapter
29
Customising preferences
The difference between "Custom1" and
"Custom2"
! A separate Custom1 curve can be created
for each source. If you make adjustments
when a curve Super Bass, Powerful,
Natural, Vocal, Flat, or Custom1 is se-
lected, the equaliser curve settings will be
memorised in Custom1.
! A Custom2 curve can be created common
to all sources. If you make adjustments
when Custom2 curve is selected, the Cus-
tom2 curve will be updated.
! The adjusted Custom1 curve is memorised
for each of the source selected, but one
curve is shared for the following sources.
— CD, ROM, DVD-V, DVD-VR, DivX
— AM and FM
— EXT1 and EXT2
— AV1 and AV2
— SD and USB
! The different source volume level can be
set between iPod and USB.
! When [Flat] is selected, no supplement or
correction is made to the sound. This is
useful to check the effect of the equaliser
curves by switching alternatively between
[Flat] and a set equaliser curve.
Touch [EQ] on the "AV Sound Settings"
1
menu.
= For details, refer to Displaying the "AV
Sound Settings" menu on page 132.
2
Touch the one of keys to select a curve
that you want to use as the basis of custo-
mising.
3
Touch [Customize].
4
Touch the frequency that you want to
adjust the level.
5
Touch [a] or [b] to adjust the level of
the equaliser band.
Each time you touch [a] or [b], the level of
the equalisation band increases or decreases.
Adjusting loudness
Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
134
Engb
Touch [Loudness] on the "AV Sound
1
Settings" menu.
= For details, refer to Displaying the "AV
Sound Settings" menu on page 132.
2
Touch [Loudness] to select the level you
want.
Each time you touch [Loudness], the level is
selected in the following order:
Off — Low — Mid — High
Using subwoofer output
The navigation system is equipped with a sub-
woofer output mechanism, which can be
turned on or off.
p Only when "Sub Woofer" is [On], you can
adjust "Phase", "Level" and "Frequency".
Touch [Sub Woofer] on the "AV Sound
1
Settings" menu.
= For details, refer to Displaying the "AV
Sound Settings" menu on page 132.
2
Touch [On] to turn subwoofer output
on.
To turn subwoofer output off, touch [Off].
3
Touch [Reverse] or [Normal] to select
the phase of subwoofer output.
Touch [+] or [–] next to "Level" to adjust
4
the output level.
+6 to –24 is displayed as the level is increased
or decreased.
Touch [c] or [d] next to "Frequency" to
5
select cut-off frequency.
Each time you touch [c] or [d], cut-off fre-
quencies are selected in the following order:
50 Hz — 63 Hz — 80 Hz — 100 Hz — 125 Hz
Only frequencies lower than those in the se-
lected range are output from the subwoofer.
Advertisement
Table of Contents
